download
Left Side Mounting Bracket includes the following: One aluminum bullet pre-attached to the bracket. One U clamp with two M6 x 30 Allen head cap screws. One M6 x 45 Allen head cap screw with 15 mm spacer. One M8 x 20 Allen head cap screw with split washer and flat washer threaded into bottom side of mounting bracket. # 2: Right Side Mounting bracket is similarly equipped to the left side described above. # 3: The Upper Rear Support Bracket is “W” shaped and comes with two aluminum bullets attached, and two “Z” shaped brackets, held in place by two M6 x 35 Allen head cap screws, matching split washers, and two 7mm spacers. # 4 : One Rear Crossbar with two attached aluminum bullets. #5 : Left Side Passenger Foot peg Bracket consisting of one large and one small aluminum plate with two M6 x 12 Allen Buttonhead cap screws. # 6 : Right side passenger foot peg bracket is similarly equipped to the left side described above . Pre-attached hardware list: For your convenience, all brackets and mounts are shipped with all bolts and spacers attached to the mounts, in their eventual final location. The following is a list of fasteners that are assembled to the brackets but are left loose to ease alignment, and to be tightened by you. Don’t forget to tighten up the mounting hardware at time of assembly. 1. Case Mounting Blocks to case: M5 x 12 Allen Buttonhead cap screws with split washers (four per block). 2. Bullets to SS Brackets and “W”: M4 x 16 Allen Buttonhead cap screws (two per bullet).
